Vutec ARTSCREEN Surface Clip Instructions User Manual download pdf

VUTEC CORPORATION

INSTALLATION INSTRUCTIONS

Surface Mount Plasma

Installation

The Plasma must be straight and not tilted for the Art

Screen to work properly. Tilting of the Plasma is not

recommended.

Referring to Figure 2, use a triangle to determine the Plasma

OD onto the wall. Verify the outline accuracy for a problem

free installation.

Determine the depth of the Plasma – from the wall to the

front bezel surface.

Determine the mounting locations for the wall mount

brackets (Figures 1 & 2). Use proper wall anchors (not

supplied) for drywall installation.

Drill pilot holes for #8 screws or install wall anchors as

required.

Install the Art Screen frame (Figure 3) around the Plasma.

Adjust the Art Screen frame so that it is center around the

Plasma. Tighten the screws.

Adjust the depth of the Art Screen frame so that it is 1/2 to

5/8 (Figure 4) inch more than the depth of the Plasma. This

clearance is required for the Art Screen to travel.

Route the motor wires to the backside for connection later.

Wood Frame Installation

A typical wood frame including the liner is

approximately 5 inches wide to properly cover the

assembly. The wood overhangs the main shell

approximately 3/4 inch when attached.

Two corner woods are attached to the backside of the

wood frame to take-up the weight.

Two spring-loaded catches and a magnetic catch will

hold the wood frame to the main shell. Simply snap

the wood frame to the shell when ready.

Referring to Figure 6, two side panels are provided for

covering the sides of the Art Screen frame. The panels

apply to the frame by Velcro strips supplied.

The Velcro strips are cut to length. Apply the black

part (Hook) of the Velcro to the sides of the frame.

Apply the white part (Loop) of the Velcro to each of

the panels (Figure 6).

Apply the side panels to the Art Screen frame for a

complete installation. The top and bottom of the Art

Screen frame are left open for proper ventilation for

the plasma.

Optionally, custom-made side panels may be installed

as desired.

Figure 2

Outlining the Plasma OD onto Wall

Figure 1

Rear View of Frame

1 2 3 4 5 6

Summary of Contents

Page 1 - Surface Mount Plasma

VUTEC CORPORATION INSTALLATION INSTRUCTIONS Surface Mount Plasma Installation The Plasma must be straight and not tilted for the Art Scree

Page 2

Electrical Connections The Art Screen comes with IR remote control for operations. It is ready for use; no wiring connections are required. Pl

Page 3 - Motor Limit Switches

3. Send the screen up halfway then stop. Send the screen down to its closed limit. The screen must stop above the desired position. If it is

Page 4 - Accessories Included

Accessories Included Description QTY. Main Shell including Artwork and Motor 1 Side Mount Bracket 2 Wall Mount Bracket 2 Wood Fr

Page 5 - Figure A

WOOD FRAME INSTALLATION & REMOVAL Note: Do not pull the wood frame straight out. The catches are designed to be separated in the peelin

Page 6 - Figure D

ART ROLLER INSTALLATION Vutec has made a significant improvement to control and reduce the vibration noise level associated with the art roller

Comments to this Manuals

No comments

Vutec ARTSCREEN Surface Clip Instructions User Manual

Browse online or download User Manual for Monitors Vutec ARTSCREEN Surface Clip Instructions. Vutec ARTSCREEN Surface Clip Instructions User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for Monitors Vutec ARTSCREEN Surface Clip Instructions