Vutec PORTA-FOLD TRUSS - Installation Instructions User Manual

Browse online or download User Manual for Monitors Vutec PORTA-FOLD TRUSS - Installation Instructions. Vutec PORTA-FOLD TRUSS - Installation Instructions User Manual

  • Download
  • Add to my manuals
  • Print
  • Page
    / 2
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 0
VUTEC CORPORATION
www.vutec.com
TEL: (954)-545-9000
FAX: (954)-545-9011
Truss Frame
INSTALLATION INSTRUCTIONS
Assembly
Figure a
1. Unfold each truss section and secure all hinge locks. Lay sections on floor
with snap-fasteners facing up. Match color code marks on corners and bolt
sections together with bolts and wing nuts (fig a).
2. Bolt support truss to top and bottom frame truss (fig c).
3. Unfold truss legs and feet. Attach legs to side frame truss at desired
heights by screwing crank bolts into the blue colored fasteners (fig a).
Height can be adjusted in six inch increments.
4. Unfold screen surface and lay over assembled frame. Starting at the
corners, snap the surface onto the screen and continue around the
sides (fig b).(Caution: Keep the protective ground cloth underneath the
surface until the assembled screen is raised upright to prevent the
surface from getting dirty - especially with rear projection surfaces.)
5. With one person supporting each side of the screen, raise the assembled unit
upright and then bolt on the feet to the bottom of the legs with bolts and wing
nuts (fig c) For larger screens, additional support should be provided for the
center while the screen is being raised.
Figure b
Figure c
Disassembly
In general, reverse the above order
.
1. Lay the protective ground cloth for the surface on the floor.
Unbolt the feet from the legs. With one person per side to
support the screen, carefully lower to the ground. With larger
screens, additional support should be provided for the center of
the screen while being lowered.
2. Carefully unsnap, remove and repack the surface
(see surface instructions).
3. Unbolt legs from frame, unlock hinges and fold.
4. Unbolt corner sections of frame. Release all hinge
locks on frame truss sections and fold. Return all
pieces to the protection case.
Page view 0
1 2

Summary of Contents

Page 1 - Truss Frame

VUTEC CORPORATION www.vutec.com TEL: (954)-545-9000 FAX: (954)-545-9011 E-MAIL: [email protected] Truss Frame INSTALLATION INSTRUCTIONS Assembly

Page 2 - Truss Trim Kit (Clip)

VUTEC CORPORATION www.vutec.com TEL: (954)-545-9000 FAX: (954)-545-9011 E-MAIL: [email protected] Truss Trim Kit (Clip) INSTALLATION INSTRUCTIONS Asse

Comments to this Manuals

No comments