Vutec ARTSCREEN Recessed Clip Instructions User Manual download pdf

INSTALLATION INSTRUCTIONS

Recessed Mount Plasma

Installation

The Plasma must be in the vertical position for the Art

Screen to work properly. Tilting of the Plasma is not

recommended.

Referring to the table in this manual; determine the wall

opening height and width.

Review Figures 6 through 7 for a set of possible installation

scenarios.

Dry wall installation requires base support as shown in

Figure 1. Additional supports to strengthen the base support

should also be considered.

Determine ventilation concept for the plasma.

Determine I/O routing of the video/audio cables and AC power

supply.

Place the main shell in the wall opening. Be sure the main shell

is level; use wood spacers (shims) as necessary. Screw the shell to the wall.

Remove the Clamp Bar and the plasma stands.

Install the stands to the plasma. Place the fender washers in the

channel to reduce slot size for tightening of the screws.

Do not tighten the screws. Place the plasma with the

stands inside the main shell. Adjust the bottom rests to

center the plasma in the vertical direction.

Remove the plasma and stand out of the shell; tighten

the screws to secure the plasma to the stands.

Place the plasma back inside the shell. Make all necessary

connections, i.e. video/audio cables, AC supply, etc.

Install the Clamp Bar. Do not tighten the screws.

Referring to Figure 4, position the plasma so that the bezel

face of the plasma is approximately 1/2 to 5/8 inch behind

the shell. This is the clearance required for the Artwork to

travel up and down.

The plasma must be centered in the shell on all sides.

Verify and adjust as necessary. Tighten the screws of the

Clamp Bar to secure its location.

It is wise to test the complete system at this time.

Finish the gaps between the main shell and the wall as

required.

Figure 2

Main Shell Assembly

Figure 1

Wall Construction

1 2 3 4 5 6 7

Summary of Contents

Page 1 - Recessed Mount Plasma

INSTALLATION INSTRUCTIONS Recessed Mount Plasma Installation The Plasma must be in the vertical position for the Art Screen to work p

Page 2

Wood Frame Installation A typical wood frame including the liner is approximately 5 inches wide to properly cover the assembly. The wood

Page 3 - Motor Limit Switches

Open and Close Limits Setting The Open limit switch has been properly set for correct stop position. It should not be adjusted unless a

Page 4

Figure 7a Figure 7b Figure 7c 60 inches Diagonal Plasma Figure 6a Figure 6b Figure 6c 40 and 50 inches Diagonal Plasmas

Page 5 - Figure 8

Accessories Included Description QTY. Frame Assembly including Artwork and Motor 1 Plasma Stand Assembly 2 Clamp Bar 1 Wood Frame (

Page 6 - Figure A

WOOD FRAME INSTALLATION & REMOVAL Note: Do not pull the wood frame straight out. The catches are designed to be separated in th

Page 7 - Figure F

ART ROLLER INSTALLATION Vutec has made a significant improvement to control and reduce the vibration noise level associated with the ar

Comments to this Manuals

No comments

Vutec ARTSCREEN Recessed Clip Instructions User Manual

Browse online or download User Manual for Monitors Vutec ARTSCREEN Recessed Clip Instructions. Vutec ARTSCREEN Recessed Clip Instructions User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for Monitors Vutec ARTSCREEN Recessed Clip Instructions